|
Post by vladfs on Apr 10, 2015 16:14:13 GMT
|
|
|
Post by george on Apr 12, 2015 20:33:00 GMT
Very nice looking Vlad! I encourage you to keep up the good work I'm still busy with my SOTS model, still lots of work to do
|
|
|
Post by vladfs on Apr 15, 2015 15:33:03 GMT
Thank you for estimation, George!
|
|
|
Post by vladfs on Apr 15, 2015 17:16:35 GMT
Fish-davit of real ship: it is 5,85m long and 24sm by27sm in cross section and has the same curve as the deck. The only one fish-davit will be set. I didn't decide yet where it will be - left or right.
|
|
|
Post by vladfs on Apr 19, 2015 14:14:02 GMT
|
|
|
Post by alexander on Apr 20, 2015 7:53:18 GMT
Nice work, Vlad!
I suspect the figure for the mainsail tacks is situated a little lower as you mounted it at your model.
Cheers, Alexander
|
|
|
Post by vladfs on Apr 20, 2015 11:48:24 GMT
Nice work, Vlad! I suspect the figure for the mainsail tacks is situated a little lower as you mounted it at your model. Cheers, Alexander Dear Alexander! The mainsail tacks are situated according photo of original. The figure is above gun-ports.
According to model 1:10 the figure is above ports too.
The lower situation as on photos is incorrectly.
Cheers, Vladimir.
|
|
|
Post by alexander on Apr 20, 2015 17:04:22 GMT
Hi Vladimir,
you are right. The lower position, as my plans (of W. Mondfeld) show it, is obviously wrong. So I have to change this on my model.
Thanks for the correction.
Cheers, Alexander
|
|
|
Post by vladfs on May 3, 2015 12:03:13 GMT
Artillery. Gun tube turned for mould. Moulds for tin cast. First result of cost of guns. Cleanning cut, drilliing, polishing.
|
|
|
Post by vladfs on May 11, 2015 11:45:49 GMT
|
|
|
Post by Peter Jenssen on May 20, 2015 4:19:48 GMT
Looks great! What metal and what blackening did you use for the guns? I don't know yet if I'm going to attempt casting. On one hand, I'm not quite happy with the Corel guns, on the other, I'm not quite comfortable with casting either.. :-) The finish view of gun tubes.
|
|
|
Post by vladfs on May 20, 2015 12:37:23 GMT
Hi, Peter! I used tin for casting. Then tin was covered arth copper by galvanisation. And copper was blackhened by "Brass Black".
|
|
|
Post by vladfs on May 28, 2015 12:44:57 GMT
|
|
|
Post by vladfs on Jun 3, 2015 11:07:35 GMT
|
|
|
Post by vladfs on Jun 15, 2015 11:42:49 GMT
Gun carriges complete set Nails
|
|